Dodge Nitro Forum banner

07 2.8 crd sxt - UCONNECT question from a newbie

256 Views 8 Replies 4 Participants Last post by  2010NitroHeat
2
Hi, picked up my nitro today and love it. I have been searching for various threads about the UCONNECT.

It comes up with UNCONNECT not available.

It doesn't have the rear mirror with the mics (i've attached a pic of the rear as there are plenty of wires into the mirror) , but there is what looks like it could be an aftermarket mic in the head console by the interior lights (pic attached) unless it part of an alarm system.
Glasses White Light Vehicle Motor vehicle
Mirror Car Vehicle Motor vehicle Automotive mirror

Is there a certain way to determine if it has been set up, where would the module be etc?

Thanks
See less See more
1 - 9 of 9 Posts
most likely you don't have it, i don't have it and my stereo comes up with the same message " uconnect not available",
the thing in the overhead console is the receiver for the alarm interior motion sensor, the transmitter is in the headliner rear left hand side,
  • Like
Reactions: 1
if you search uconnect on this forum there is plenty of info, your question has been asked loads of times, i just can't remember what is needed to get it working, but a new visor, uconnect module and some dealer programming springs to mind,
i don't recall many people actualy going ahead and getting it done, i think most people simply replace the head unit with an upto date touchscreen,
  • Like
Reactions: 1
The auto dimming mirror with dual mic has them mounted on the very top--you'll feel a rectangular screen on the top on each side.
  • Like
Reactions: 1
mine has the auto dimming mirror does that mean it already has the dual mic's
mine has the auto dimming mirror does that mean it already has the dual mic's
It might. Look on the top. You'll see the grille/hole for the mic. There's foam right underneath it.
It might. Look on the top. You'll see the grille/hole for the mic. There's foam right underneath it.
just looked unfortunately i don't have the mic's, just the sensor for the auto dim, bummer
just looked unfortunately i don't have the mic's, just the sensor for the auto dim, bummer
You want: mopar 55157457AA
I found one on ebay. I lucked out and it came with about a foot of the harness and the plug. So I created a custom harness crimped to that to wire it to my maestro harness.

The actual harness is available on amazon for $90.
It's pretty easy to run the harness if you know how to expose your dash and A-pillar (it all comes off pretty easily).

There are two possible harnesses:
mopar 82211666
mopar 82211868

If you search those you can find the pdf install instructions which is damn near as good as a Lego instruction booklet. You'll see what's involved and how to choose which one you need to buy or create.
I had the stereo without the UConnect functions, and I just installed a Jensen CAR710W, with Android Auto and Apple Car Play. It was really easy, and came with a microphone that I installed at the top of the driver's A pillar. I installed it with the Crux SOOCR-26 Wiring Interface, which makes it work with CANBUS system, and the factory amplifier, if you have one. You can also get a module that lets you use the steering wheel controls, if you have them. I didn't.

Gadget Font Communication Device Technology Audio equipment


Even though this head unit was fairly cheap, it's still way more advanced than the UConnect system.
See less See more
  • Like
Reactions: 1
1 - 9 of 9 Posts
Top