Dodge Nitro Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
Hello, mu 2007 dodge nitro , driver back seat sensor is not working properly , I have try closing it by closing hard the door but the ajar will turn of and then light up again . Can somebody please tell me where I can unplug the sensor.

BTW :I try reading old post about this but went i click the threads, it say oppss something went wrong.
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #3 ·
Yes it was back seat sensor..
I took out the grey door panel, but could not
Fully take out the black one and saw the door sensor and was able to unplug it from the small side hole that the door has with a pair of tweezers.
Can this on the run long cause any damage to the vehicle computer?
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #5 ·
My bad, my english is not the best I wanted to say the door sensor. The back door sensor is what tell you went you leave a door open or not closed correctly on the dash board
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top