Dodge Nitro Forum banner
1 - 11 of 11 Posts

· Registered
Joined
·
43 Posts
Discussion Starter · #1 · (Edited)
Ok, so for fun, I added a 6th LCD monitor. I installed a 15" flipdown on the inside of the tailgate. Makes a perfect tailgating vehicle. With the PS2 installed, we were actually playing Rock Band at my last car show. Seemed to be a real crowd pleaser. =) And to help draw a crowd, was my new JL Audio TW-5 13.5 " sub in a neat custom fiberglass enclosure. Powering the TW-5 is a JL Audio A-1400 amp and powering the Kenwood excelon door speakers is a JL Audio A-4300 Amp. With the Stinger 1 farad cap in the middle to help, It really gives a great , clean sound. Here are some pics. Lets have some feedback =)
 

· Registered
Joined
·
7,632 Posts
very nice setup, looks very clean....is that under the load n go or did you have to remove it?:rep:

does the flip down lay snug in the rear area?
 

· Registered
Joined
·
43 Posts
Discussion Starter · #4 ·
Thanks! The setup does fit under the load and go, however I had to make a cut out for the capacitor to fit. The flip down fits nicely but you do have to make a U shaped mount out of wood to mount it to so it would clear the windshield washer motor area. You also have to re-enforce under the plastic trim panel to keep it stable.
 

· Registered
Joined
·
7,632 Posts
you should do a how to write up when you get the chance in case others wanna do the same!
 

· Premium Member
07Lifted,4X4,6sp-man,3.7L
Joined
·
29,175 Posts
Very Nice work siggy401. :smileup:
:rep:
 

· Registered
Joined
·
523 Posts
Thanks! The setup does fit under the load and go, however I had to make a cut out for the capacitor to fit. The flip down fits nicely but you do have to make a U shaped mount out of wood to mount it to so it would clear the windshield washer motor area. You also have to re-enforce under the plastic trim panel to keep it stable.
Is it a flux capacitor? Lol a little Back To The Future action. That would be sweet. Seriously that is a great ride.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top