Joined
·
1,786 Posts
Well I got board this weekend, my wife was baby setting some children of a lady she works with over the weekend and I decided to put a sub in the nitro. I had gotten two 10” solo barics and a Kicker wiring kit awhile back to glass a box in the nitro but have not had time for that kind of work and I had a 750.1 that I took out of my truck that I traded in when I got the Nitro. All it ended up costing me was a sheet of MDF, some brads and two cans of textured paint. I had been pondering over the idea of getting one of my buddies at kicker to get me a box but all there boxes are tuned high. So I built this bad boy tuned at 32Hz. I have always wanted to build a box that low. I also have the sub wired up at 4Ohm so the load on the amp is really low, very efficient and cents the box is tuned so low that power is about right for the low back presser on the drive motor in the woofer.
Click To Enlarge
Enclosure

Temp amp install I am wanting to add a amp for some new highs later so I just did a temp amp install I didn’t want any non necessary holds in anything.

1/0 gauge power and ground wire ran for future upgrades

Where I ran the 1/0 power wire. I found a none used rubber grommet on the driver side worked great.
Inside shot

Under hood shot

New battery and cable attached.

http://www.youtube.com/watch?v=6f8w-QWyMjU
Click To Enlarge
Enclosure

Temp amp install I am wanting to add a amp for some new highs later so I just did a temp amp install I didn’t want any non necessary holds in anything.

1/0 gauge power and ground wire ran for future upgrades

Where I ran the 1/0 power wire. I found a none used rubber grommet on the driver side worked great.
Inside shot

Under hood shot

New battery and cable attached.

http://www.youtube.com/watch?v=6f8w-QWyMjU