Dodge Nitro Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
92 Posts
Discussion Starter · #1 ·
Anyone have problems with the rear filler panel (the 2 flaps that fold up and down when you fold the seats). The cheap plastic after bending several times breaks, bad design. Plastic bending several times and doesnt break... that would NEVER happen! Anyone get that replaced under manufactures warranty? I took it and said since it was broke they wont replace it even, its broke cause of the bad design. And the other half is intact but barely. Or any suggestions of how to fix it???
 

· Registered
Joined
·
5 Posts
Bought my 2008 Stone R/T used and noticed the same problem. Although I have not tried it yet I will probably look at using small piano hinges. Just need to figure out how to attach them so they remain hidden.

Anyone have problems with the rear filler panel (the 2 flaps that fold up and down when you fold the seats). The cheap plastic after bending several times breaks, bad design. Plastic bending several times and doesnt break... that would NEVER happen! Anyone get that replaced under manufactures warranty? I took it and said since it was broke they wont replace it even, its broke cause of the bad design. And the other half is intact but barely. Or any suggestions of how to fix it???
 

· Registered
Joined
·
7,426 Posts
I drive an 08/SLT and replaced that under warranty from the dealer.
No questions asked.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top