Dodge Nitro Forum banner
1 - 4 of 131 Posts

· Registered
Joined
·
182 Posts
Factory Upgrades

Great Job Nitro Tech, BCH, & lilsalmon!

Kicker will be providing detailed audio integration specs (audio voltage levels etc) in a training session to be held march 30th thru April 1st, I will pass that information along once I recieve.

Mopar/Kicker Upgrades 77KICK10, 77KICK15, & 77KICK19 are the ones available for the Nitro. The upgrades replace factory speaker locations , amplifier, and add a dual 10" square sub woofer enclosure.
:jammin:
 

· Registered
Joined
·
182 Posts
Illumination Wire Connection

Illumination can be found without using a harness in the center console at the gear shifter bulb, or at the 2 wheel/4 wheel drive selector switch.

Illumination wire is Orange/Gray stripe. If tapped at the bulb itself you will have to use a voltmeter to determine the correct Blue wire.

You cannot tap into the illumination of the vehicle for an aftermarket headunit because it is controlled through the CAN BUS.

The only way to utilize illumination is by purchasing a harness. The only one out that will have the illumination wire is the CHTO-03 by Metra.

-Lil'
 

· Registered
Joined
·
182 Posts
Illumination Wire Connection

Illumination can be found without using a harness in the center console at the gear shifter bulb, or at the 2 wheel/4 wheel drive selector switch.

Illumination wire is Orange/Gray stripe. If tapped at the bulb itself you will have to use a voltmeter to determine the correct Blue wire.


OK, I know this has been asked, but it hasnt been answered. I do not have a wire harness and need to tie into the illumination for headlights on and off, to have dimmer control on my Aftermarket Head Unit. Does anyone have any info as to which wire we tap into for that? I know the EIA states it should be Orange/White, is it safe to say if I tap into the Orange/White on the Factory Harness, that would be the illumination control to have my headunit dim when headlights are turned on?
 
1 - 4 of 131 Posts
Top