[NitroTech]

Here's the complete radio connector pinouts with drawings to identify each connector. Once I've got pics of the back of the radio I add those also.
If anyone has requests for specific connector pinouts or component locations within yor Nitro just ask.

 

[NitroTech]

KickerNitro, you are partially correct on the illumination. On a 42RLE transmission the panel lamps driver circuit is E12 OR/GY. On a NAG1 which would be found in an R/T with the 4.0L there is no panel lamps drivers at the shifter connector.

 

[NitroTech]

I have my dash apart and these colors don't match up. Pin 2 is white/orange and Pin 13 is white/gray. hmmm....

Could you specify which connector you are referring to?

 

[NitroTech]

Those are definitely the IHS BUS circuits. Sometimes there are discrepancies between the diagrams and the vehicle.

 

[NitroTech]

Ok so has anyone confirmed that it's possible to just drop in a MyGIG system to replace the 6-disc changer? I've got one on order and am thinking about doing the installation myself. In the PDF I see Multimedia/Video Radio, but I'm not sure that is equivalent to "MyGIG." Does anyone have any input on the connectors (no pun intended) for MyGIG system?

I'd ask member Headbusa if he could post some pics of the MyGIG he purchased. Once we see what connectors are there it can be confirmed if they are the same as the Sat. radio. They'll likely be the same. Check it out http://www.nitroforumz.com/showthread.php?t=2618

 

[NitroTech]

Right here JasOz. http://www.nitroforumz.com/showthread.php?t=1458

 

[NitroTech]

Which pin or wire do I connect the 12 volt constant to in order to keep the memory? Do I use the CAN bus +?

Connector C2 Grey 22 way Pin 1 18RD Fused B+ (IOD)

 

[NitroTech]

Yes it will. Plug n Play.

 

[NitroTech]

Where does the other end of the C1 connector go (location)?

That connector goes to the Handsfree Module (Telematics Module P/N 5064469AA). Also the 22-WAY body connector for the HFM is P/N 05083221AA. Hope that helps. :smileup:

 

[NitroTech]

Just speculating, but I would only expect audio out from connector C3 if the rear entertainment mode of the head unit is enabled.

 

[NitroTech]

Whereas aftermarket radios have a switched ignition 12v feed to the radio to turn it on, Chrysler radio's don't exactly work the same way. The CAN-BUS circuits tell the radio to turn on. In order to turn on a MyGIG it would require receiving the same BUS message that is transmitted over the CAN Bus network. If you can duplicate this or find a way around it then you could install a MyGIG in any vehicle. I have no idea how to do this. Good luck! :smileup: