[Theos_11nitro]

Ok let me start I know, I know.....disconnect the battery.
Well since I am posting a question you know I didn't.
I am installing a new radio as per some of the postings on here Nitro radios aren't good.
I replaced the only fuse that I can find blown. So my question is....
Are there any other fuses connected to the yellow/green constant power wire for the radio?
Thank you all in advance.

 

[Nitrogen]

i don't see a yellow/green for the power in the wiring diagrams,
you need to check fuses M10 and M12,
do you have the stock Amplfier ?,

 

[Theos_11nitro]

Oops yes correct it is a yellow/red radio power wire
I replaced the M12 (30 amp) fuse since it was the only one blown.....still no power to radio everything else is good.
Any ideas guys?

 

[Nitrogen]

fuse M12 feeds the amplifier, fuse M10 feeds the radio,
if both fuses are good, next step is to disconnect the negative battery terminal for 10 minutes then reconnect this will reset the vehicles computers,

 

[Tunes]

Which harness did you install? I'm thinking you may have the ignition, battery power, amp remote turn on or the amplified antenna remote wire connected wrong. It could also be the wrong harness prohramming as well since there are several options available. Access uses a programable harness which is a bitch to get working in Chrysler vehicles at times. I always use the PAC CH11 harness and never had any issues