Dodge Nitro Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
39 Posts
Discussion Starter · #1 ·
looking to replace stock muffler with less restictive one(from autoanything). have purchased cai. need to know what to buy, what is resonator ,where is resonator, do i take it out, what tip to buy, any collars or clamps needed, etc.. i have a friend doing it for me but need to know particulars.. any help is appreciated, would like to order tonight....this will mainly be family car so main objeective is to keep interior noise to a bare minimum and the outside not sounding like a puss is driving..
thanks again for your help.
todd
 

· Registered
Joined
·
4,968 Posts
looking to replace stock muffler with less restictive one(from autoanything). have purchased cai. need to know what to buy, what is resonator ,where is resonator, do i take it out, what tip to buy, any collars or clamps needed, etc.. i have a friend doing it for me but need to know particulars.. any help is appreciated, would like to order tonight....this will mainly be family car so main objeective is to keep interior noise to a bare minimum and the outside not sounding like a puss is driving..
thanks again for your help.
todd
I bought a Flowmaster 50 muffler and Flowmaster chromed tips from Summit Racing website and had them shipped to NC where a shop did the dual exhaust install for me. From what I understand, they welded the muffler to the existing pipes coming from the cat to the new muffler and added new pipes to the back of the Nitro and bolted on the tips. If you buy the parts, a reputable shop should be able to fix you up!
 

· Registered
Joined
·
39 Posts
Discussion Starter · #3 ·
I bought a Flowmaster 50 muffler and Flowmaster chromed tips from Summit Racing website and had them shipped to NC where a shop did the dual exhaust install for me. From what I understand, they welded the muffler to the existing pipes coming from the cat to the new muffler and added new pipes to the back of the Nitro and bolted on the tips. If you buy the parts, a reputable shop should be able to fix you up!



looking to just cut off the existing muffler and replacing only it.....possible?
 

· Dodge Nitro Forum
Joined
·
9,544 Posts
If you look underneath the middle you will see the muffler. The resonator is the smaller box at the end near the tailpipe. You can lose the resonator and fit just a muffler. Flowmaster, Magnaflow are two examples of aftermarket manufacturers. Alternatively you can install a full catback system from those makers and it should come with all the hardware required. they bolt on where your existing system bolts to the cat converter.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top