[monica m]

The red lightning bolt is the electronic throttle body. Mine came on and i went to NAPA and got some throttle body cleaner for like $8, removed the throttle body and cleaned it. Put it back on and erased all codes. If you clean your throttle body make sure you do not spray it directly. I sprayed a tooth brush then lightly scrubbed all the build up off. You'll want to open the blade on it and support it (I used a screw driver) and clean the edges of the blade. When you go to close the blade do not let it pop back in place. Use your finger to slowly close it back. After cleaning use a lent free cloth (I used blue shop paper towels) to wipe it clean and dry. Also on one side of the throttle body you will see a black block. It contains the electrical components for the throttle body. Do not let it get soaking wet or you will have to buy a new one. As far as the temp gauge goes it could be the thermostat is stuck, a sensor is bad or unplugged, or a wiring issue. Unless anyone else has other ideas.

Thank you any idea why my fan continues to run and not stop and go?

 

[monica m]

Only when car is running … had the relay fan replace and now just continues to run until shut car

 

[monica m]

It could be a shorted wire or a clogged cooling system or a coolant temperature sensor

I think your right I got a code

 

[monica m]

Hey I was wondering what was done to resolve the code I'm fighting with the same one now.

Nope I haven’t gone to mechanic lights still on and fan continues to run… also ac won’t work… I just make sure I have coolant